LG Electronics WT901CW Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 14)

•

INSTALLATION INSTRUCTIONS

CONNECT THE WATER LINES

LG recommends the use of LG hoses. Any leaking,

property damage, or damage to the washing ma-

chine caused by an improper installation or by the

use of non-LG hoses is not covered under the terms

of the LG warranty and is the sole responsibility of

the customer and/or an installer. For your safety, and

for extended product life, we recommend using high-

quality LG components. LG is not responsible for pro-

duct malfunction or damage caused by the use of se-

parately purchased non-LG parts. Contact LG Custo-

mer Service for assistance in buying hoses: 1-800-

243-0000.

Water supply pressure must be between 14.5 psi

and 116 psi (100 - 800 kPa). If the water supply pressure

is more than 116 psi, a pressure reducing valve must

be installed.

Periodically check the hose for cracks, leaks, and

wear, and replace the hose if necessary.

Make sure that the water lines are not stretched,

pinched, crushed, or kinked.

The

washer should never be installed or stored in a

location subject to freezing temperatures. Damage to

the water lines and internal mechanisms of the washer

can result. If the washer was exposed to freezing tem

peratures prior to installation, allow it to stand at room

temperature for several hours before use and check for

leaks prior to operation.

1. Inspect the threaded fitting on each hose and

make sure there is a rubber seal in place in both

ends.

2. Connect the water supply hoses to the HOT and

COLD water faucets tightly by hand and then tight-

en another 2/3 turn with pliers.

Water Faucet

3. Always run a gallon or two of water through each

inlet hose to flush dirt, scale and other debris out

of the water lines. Doing so will help prevent future

problems with clogged filter screens, and will also

allow you to verify which hose is hot and which

is cold.

4. Attach the hot water line to the hot water inlet (o-

water line to the cold water inlet (blue) on the back

of the washer.

Tighten the fittings securely. Turn ON both fau-

cets

all

the way and check for leaks at both ends

of the hoses.

NOTE: Be careful not to cross-thread the hose fit-

tings. This will damage the valve and could result in

property damage from leaks.

Rubber Seal

Water Hose

(to tap)

Water Hose

(to water inlet

on washer)

Rubber Seal

Do not reuse old hoses.

Only use new hoses

when you install the washing machine. Old

hoses could leak or burst causing flooding and

property damage.

Do not overtighten the hoses.

Overtightening

can damage the valves resulting in leaking and

property damage.

Do not overtighten.

Damage to the coupling

can result.

Cold water inlet

Hot water inlet

WARNING

range) on the back of the washer. Attach the cold

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Kommentare zu diesen Handbüchern

Keine Kommentare

LG Electronics WT901CW Gebrauchs- und Pflegehandbuch Seite 14

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Waschmaschinen LG Electronics WT901CW